Checking Valid Users and Groups from your Directory Service

You can check which users and groups from your directory service can be synchronized via LDAP depending on the configured LDAP filter.

The switch Synchronization of groups and users is enabled.

Under Service Dashboard > LDAP Connection, you have the possibility to check which users and groups from your directory service can be synchronized depending on the current filter settings. This allows you to customize the LDAP filter according to your needs.

  1. Navigate to Service Dashboard > LDAP Connection.
  2. Click on Show valid users and groups below the switch Synchronization of groups and users.

    The window LDAP test opens. The valid users and groups are checked. When the check is complete, the results are displayed by user and group.

    Figure 1: LDAP check
  3. Select the desired option from the drop-down menu on the left to view the corresponding information. The following options are available:
    • Users: Valid users that can be synchronized.
    • Groups: Valid groups that can be synchronized.
    • Log: Protocol of the LDAP check.
  4. Check whether the displayed data corresponds to your expectations regarding the content of your directory service.
  5. Click on Close.

    The window closes.

Valid users and groups from your directory service have been checked.